DSL Extreme
Where are you? Support > Knowledge Base > DSL Support > Modems > SpeedStream > Efficient SpeedStream 5100-a
 

Efficient SpeedStream 5100-a  

How to set up your SpeedStream 5100-a modem
 
Use the set up instructions and images below to make sure that your Efficient SpeedStream 5100-a modem is set up properly.


 


 


 


 



 
Tips:
  • Test the power outlet that your DSL modem is plugged into by plugging in a lamp or other electronic device to make sure the outlet is working.
  • Check your Ethernet cable. It may be damaged and need to be replaced
 
How to interpret your Efficient SpeedStream 5100-a modem lights
After you have tried power cycling your DSL modem, checking your setup and DSL filters, you should look at the lights on the front of the modem panel to check your connection status.
  1. When powering up the modem, all four lights will be green for approximately 30 seconds. Observing the "Power" light, make sure that the power self-test completes successfully and the light turns a steady green.
  2. Make sure that the modem is synchronized with the ADSL line card at the other end of the circuit by checking the "DSL" light. It may take up to 70 seconds for the modem to synchronize, at which point the "DSL" light will turn to a steady green.
  3. Verify that the modem is properly wired to your computer's Network Interface Card (NIC) by checking that the "Ethernet" light is a steady green.
  4. Check that your modem is sending and receiving data by observing the "Activity" light. It will vary between steady and blinking green light when the modem is transmitting data.
The following chart explains what the lights on the front panel of the Efficient SpeedStream 5100-a modem indicate. Use this chart below to check the connection status after the initial power up.
Modem Light Behavior
Unlit
Blinking Green
Steady Green
"Power"
Modem is not getting power
Check modem set up
Power is on
"Ethernet"
No Ethernet link detected
Problem with network card or cable
Ethernet link between PC and modem established
"DSL"
DSL signal is not detected
Check modem setup (make sure your DSL line filters are properly setup)
DSL line is ready for data traffic
"Activity"
No network activity (this is OK)
Normal DSL traffic flow
Normal DSL traffic flow

 Dan




 

Search our Knowledge Base

Do the links above not match what problem you're trying to solve or question you might have? With over 600 articles and growing our Knowledge Base most likely has what you're looking for.

Enter a Search Term: Or do an Advanced Search
 

Don't want to search? Go to our Knowledge Base directly

Send an Email to a Representative

Sales & Information

Have some pre-sales questions about our packages or features?

Billing Department

Have a question about your bill or upgrading your package?

Technical Support

Having problems with your Connection? Or setting up your email?

02
    
  I want to thank the person that helped me. They were great and I learned 2 new things about my email.  
 

From Talia S.
 
t
  • @wasi_r @DSL Extreme Thanks for the awesome service. I am loving it. Also thanks to @leolaporte and @TWiT
  • @jank0 Wanted to thank @DSL Extreme